Haas Door Ribbed Steel Doors

     


 

 

Models 220, 224, 224E, 224RP
Ribbed Steel Sectional Doors

Brochure Download

 

 

 

 

 

 

20/24/Nominal 24 Gauge Steel Sectional Doors Models 220/224/224E have a semi-flush panel configuration that create a pleasing horizontal-line effect. All Models 220/224/224E steel doors are hot-dipped galvanized steel with epoxy prime coat and top coat of white.

A.  Width: 220/224 - 24'-2" max. 224E - 16'2" max.
B.  Height: 16'1" max.
C.  Maximum square feet: 220/224 - 384, 224E - 256
D.  Thickness: 2"

Low Headroom Applications: 2" double track LHR requires 12" for front-mount springs, and 6-1/2" for rear-mounted springs.
High Lift Applications: For high-lift measurements, measure your actual unobstructed headroom and subtract 12". This will determine your added high lift.
Straight Incline Vertical Applications: Requires double the door height plus 24".
Vertical Lift Breakaway: Please consult with your Haas Door Dealer.

In normal installation the bottom of the horizontal track lies 7" above the top of the opening, and parallel to the floor. The spring and drum assembly extends above, and requires additional headroom. The amount of headroom required depends on the door height.

Vertical reinforcing members are attached to both the upper and lower horizontal meeting rails and to intermediate points of the panel to provide added rigidity. Heavy gauge galvanized steel intermediate hinges are bolted to the vertical members at all intermediate points.

Standard lock is inside slide bolt. Optional locking device utilizes a spring loaded lock bar, inside and outside lock handles and 5 pin cylinder.

Weatherproof section joint. Top and bottom meeting rails are roll formed to provide a tongue & groove joint.

The bottom section is reinforced with a full-length, retainer with a flexible vinyl astragal that has been designed for all-weather protection.

Adjustable top roller bracket, fabricated from heavy gauge galvanized steel, can be easily adjusted to provide positive seal at the header.

Combination hinge/roller brackets are fabricated from 14 gauge galvanized steel and are attached to the end stiles with machine screws. All rollers have continuous steel rim and ten 1/4" diameter hardened ball bearings in case-hardened inner and outer races.

Bottom corner bracket is fabricated from heavy gauge galvanized steel. Bracket is attached to bottom rail and end stile to form a lifting cradle and also holds cable assembly securely in position at each side of door.

Window Options

Optional Insulation
 

Model
Insulation
Back Panel
U
R
224-L (24ga)
1-5/8" rigid polystyrene
matte black
.135
7.45
224-S (24ga)
1-5/8" rigid polystyrene
26 gauge steel
.135
7.45

 

 



 



 




 

Optional Glazing

 

 

© 2006-2009 Candoor Ltd. All rights reserved

Designed and Maintained by WSI Internet Marketing Mississauga